Measuring in 2D mode

<< Click to Display Table of Contents >>

Navigation:  User Interface > Viewer > Getting Information >

Measuring in 2D mode

CADEditorX has a group of instruments allowing to measure the elements of a drawing. The measurements can be performed in meters, millimeters and inches regardless of the units in which the drawing is made. It is possible to set a customer scale factor. The instruments are available in all the versions and modes of the program.

ico_measure distance Distance

This command allows measuring a distance between two points in the drawing.

ico_measure polyline Polyline Length

This command allows measuring the length of polyline sections in the drawing and the angle formed by these lines.

ico_measure area Area

This command allows measuring an area in the drawing.

Measure panel

The floating panel in which the performed measurements are displayed.

Go to CADEditorX