Bad import of step file
Posted: 20 Dec 2023, 00:04
I generated a STEP file with cadQuery, its quite simple.
However, viewing (and subsequent re-export) in ABViewer 15 has an artifact on one of the faces which hosts a hole cut.
FreeCAD imports correctly, and the viewer I use in vscode in development gets it right too.
File attached - there is a very thin fillament across part of the hole. I've had similar artifacts from numerical precision in OpenSCAD (not exporting, just internally) but I believe teh STEP format should not be problematic.
However, viewing (and subsequent re-export) in ABViewer 15 has an artifact on one of the faces which hosts a hole cut.
FreeCAD imports correctly, and the viewer I use in vscode in development gets it right too.
File attached - there is a very thin fillament across part of the hole. I've had similar artifacts from numerical precision in OpenSCAD (not exporting, just internally) but I believe teh STEP format should not be problematic.